The MSD 31459 Super Conductor Spark Plug Wire Set is a custom-fit, 8.5mm performance wire set designed specifically for Chevy Corvettes equipped with the 350 TPI engine and HEI ignition. Engineered from the inside out, these wires deliver incredibly low resistance without electronic interference, ensuring maximum spark energy reaches the plugs every time.
Ultra-Low Resistance Core:
At just 40–50 ohms of resistance per 12 inches — the lowest of any helically wound wire — the Super Conductor uses a copper alloy conductor wound tightly around a special center core. Each finished foot of wire contains over 40 feet of tightly wound conductor, maximizing conductivity and minimizing energy loss.
Built-In EMI Suppression:
The tight winding combined with a ferro-magnetic impregnated center core creates a highly effective Electro Magnetic Interference (EMI) choke, delivering RFI suppression equivalent to a 1,500-ohm wire. This keeps interference contained within the wire so it cannot disrupt sensitive electronics on the vehicle.
Key Features:
- 8.5mm diameter spiral core wire in red jacket
- 40–50 ohms resistance per foot — lowest of any helically wound wire
- RFI suppression equivalent to a 1,500-ohm wire
- Proprietary silicone/synthetic outer sleeve — highly resistant to heat, abrasion, and tears
- Dual Crimp stainless steel terminals with snap-locks — one crimp for the sleeve, one for the conductor
- High-temperature silicone boots — seven 90-degree boots and one straight boot
- Male/HEI distributor terminal ends with gray distributor boot
- Wires are pre-cut to exact lengths for a direct bolt-on fit
- Includes clip-on cylinder markers for easy identification during installation
- Sold as a complete 8-wire set
- CARB compliant — legal for use on emissions-controlled vehicles
- Limited 1-Year Warranty
Wire Lengths (by cylinder):
- Cylinder 1: 45 in.
- Cylinder 2: 41 in.
- Cylinder 3: 41 in.
- Cylinder 4: 33 in.
- Cylinder 5: 26 in.
- Cylinder 6: 28 in.
- Cylinder 7: 26 in.
- Cylinder 8: 26 in.
The MSD 31459 Super Conductor Wire Set is a direct, no-hassle upgrade over factory ignition wires, delivering measurably more spark energy for improved throttle response and engine efficiency.