RADIUM Engineering 20-0565-FL PCV Catch Can Kit for Nissan R35 GT-R with Fluid Lock

The RADIUM Engineering 20-0565-FL is a precision-engineered PCV catch can kit designed specifically for 2012+ Nissan R35 GT-R models equipped with a factory strut bar. This single catch can kit runs inline between the PCV valve and the intake manifold, mounting in the left-hand side of the engine bay near the brake master cylinder.

How It Works:

During idle, cruising, and deceleration, the PCV hose experiences metered vacuum that would normally draw unwanted crankcase vapor, unspent fuel, and oil sludge into the intake manifold immediately after a high load run. This catch can intercepts the oil and blow-by liquids to prevent them from entering the intake manifold.

Key Features:

• Fluid Lock technology with patented mechanism that prevents reservoir overfilling and traps collected fluids until emptied
• Large 10AN ORB ports, 4AN ORB drain port, 2-step oil separation baffling, and O-ring sealed dipstick
• Machined from solid 6061 aluminum with O-ring sealed halves and ports, safe for pressurized forced induction applications
• Closed-loop system that does not vent to atmosphere, making it emissions and track legal while promoting negative crankcase pressure for optimal performance
• Mounts using factory holes with no cutting, drilling, or permanent modifications required
• Built-in dipstick allows easy inspection of accumulated fluid
• 7 fluid ounce capacity, 4.9 inches height (without fittings), 2.45 inches outside diameter

Included Components:

• Anodized oil catch can with integrated condenser and dipstick
• Anodized aluminum R35 GT-R specific mounting brackets
• Anodized aluminum AN adapter fittings and hose ends
• Stainless steel mounting hardware
• RADIUM Engineering PCV hose

Important Notes:

This PCV kit is NOT directly compatible with 2008-2011 GT-Rs which did not have an OEM strut bar. The kit is compatible and recommended to be used with the dual CCV catch can kit (20-0555-FL) for maximum engine protection. No inline check valve is required since RADIUM catch cans are pressure sealed, permitting direct intake manifold connection.