SPC Performance 23409 Camber Jeep Sleeve - 0

The SPC Performance 23409 camber adjustment sleeve provides precise front suspension geometry correction for Jeep Wrangler JL models. This 0.0° (neutral) camber sleeve replaces the factory camber sleeve that connects the upper ball joint to the steering knuckle, allowing you to fine-tune front wheel alignment.

Key Features:

• 0.0° neutral camber sleeve for baseline alignment adjustment
• Hex design with chromate-free finish certified to 700-hour salt spray test for superior corrosion resistance
• Works with SPC's full range of offset sleeves (+0.25°, +0.5°, +0.75°, +1.0°, +1.25°) for precise camber adjustment
• Approximately 0.5 hour installation time per side
• One kit required per wheel

Application Notes:

Most Jeep Wrangler JL models come from the factory with a +0.25° camber sleeve installed. To determine the correct replacement sleeve, identify your current sleeve offset and calculate the change needed to achieve proper alignment specifications. For example, if your JL has the factory +0.25° sleeve and you need 0.5° more negative camber, you would use this 0.0° sleeve (23409) or consider the full six-piece set for maximum adjustment flexibility.

This precision-engineered bushing sleeve is designed specifically for Jeep Wrangler JL front suspension geometry correction, particularly useful after lift kit installation or for vehicles experiencing uneven tire wear due to camber misalignment.