The HKS 4202-RZ010 is a vehicle-specific wiring harness (Type ZP5-4) designed for use with the HKS F-CON iS and F-CON V Pro engine management systems. This plug-and-play harness provides a direct, clean interface between the F-CON V Pro unit and the factory ECU connector, eliminating the need for cutting or splicing OEM wiring.
The F-CON V Pro is a full-featured standalone piggyback engine management system that interfaces directly with the factory Engine Control Unit to provide precise fuel and ignition timing control. With up to 4 selectable trim maps for different fuel octane ratings and a 32×32 resolution for both fuel and timing maps, the F-CON V Pro delivers the granular tuning control required for serious performance builds.
The system supports up to eight injectors in D Jetro or L Jetro configurations, with injector firing modes including batch, sequential, and staged. Drive-by-wire vehicle compatibility is also supported. Tuning and programming are performed via the HKS Power Writer software, available exclusively to Certified HKS Pro Dealers.
F-CON V Pro 3.3 Features Include:
- Up to 4 selectable fuel trim maps for multiple octane ratings
- 32×32 resolution fuel and ignition timing maps
- Control of up to 8 injectors — batch, sequential, or staged firing
- Drive-by-wire vehicle compatibility
- A/F Feedback control with user-defined target air/fuel ratio
- Full data logging: speed, RPM, water temp, intake temp, timing, boost, injector duty cycle, and more
- Airflow input voltage monitoring
- Direct inputs for fuel pressure, oil pressure, and oil temperature
- Compatibility with HKS A/F Knock Amp 2 (AFK)
- Deceleration fuel cut by vehicle speed for improved low-speed drivability
- Flat shift (wide open throttle) RPM control
- Pit lane speed limiter
- HKS Valcon compatibility
- Improved Idle Control Valve (ICV) control
- Error code reporting and memory function
- Oil pressure and oil temperature warning light output
- RPM, ignition cut, and data logging warning/indicator light output
Note: The F-CON V Pro version 3.3 is not compatible with the HKS F-CON Navigator or Navigator Pro. Tuning and installation must be performed by an authorized HKS Certified Pro Dealer.