The H&R TRAK+ DRM Series Wheel Spacers (Part# 952151095) are a premium hubcentric spacer solution engineered to maximize your vehicle's track width for improved handling dynamics, enhanced lateral stability, and an aggressive, flush wheel fitment. Sold as a pair, these spacers are manufactured from a proprietary aluminum/magnesium alloy and hard anodized for lasting durability.
About the DRM Series
The DRM Series provides 40–90mm of track widening. DRM spacers bolt directly to the hub using the vehicle's existing wheel studs and included special nuts. The wheel then bolts to the new DRM wheel studs integrated into the spacer. This design makes DRM spacers one of the most robust and secure options in the TRAK+ lineup — no additional wheel bolts need to be sourced separately.
Key Features:
- Hubcentric design — centers precisely on the vehicle hub for vibration-free fitment
- 40–90mm track widening — maximizes vehicle track width for improved stance and handling
- Proprietary aluminum/magnesium alloy construction — up to 70% lighter than comparable steel spacers
- Hard anodized finish — provides a tough, corrosion-resistant surface
- Includes special nuts and DRM wheel studs — complete hardware included for installation
- Lowers roll center and increases lateral stability — measurable performance benefit, not just cosmetic
- Compatible with winter wheel and snow tire setups
- Sold as a pair
TRAK+ Series Overview
H&R offers multiple TRAK+ spacer configurations to suit different track widening needs:
- DR Series (10–40mm): Fits between wheel and hub; requires longer wheel bolts (ordered separately).
- DRS Series (10–40mm): Fits between wheel and hub; requires replacement of existing wheel studs with longer included studs.
- DRA Series (40–60mm): Bolts to hub with included special wheel bolts; provides new threaded holes for wheel bolts.
- DRM Series (40–90mm): Bolts to hub using existing wheel studs and included special nuts; wheel bolts to new integrated DRM wheel studs.
Wheel Bolt Safety Guidelines
When sourcing wheel bolts for spacer applications, observe the following minimum engagement (load-bearing shaft length) requirements:
- M12 × 1.25 — minimum 8.0 turns / ~10mm load-bearing shaft
- M12 × 1.50 — minimum 6.5 turns / ~10mm load-bearing shaft
- M12 × 1.75 — minimum 6.5 turns / ~12mm load-bearing shaft
- M14 × 1.25 — minimum 9.0 turns / ~12mm load-bearing shaft
- M14 × 1.50 — minimum 7.5 turns / ~12mm load-bearing shaft
- 1/2″ UNF — minimum 8.0 turns / ~11mm load-bearing shaft
Bolt head style must match the original: taper 60° (end digit 01), round head M12/d24mm or M14/d28mm (end digit 02), round head M12/d26mm OE VAG (end digit 03), or flat head Porsche OE M14×1.5 (end digit 06). New bolts must be longer than originals by the spacer thickness used. Always verify clearance between wheel bolts and brake components (including ABS sensors) by rotating the wheel by hand after installation.