The H&R TRAK+ Wheel Adapters (Part #70235571) are precision-engineered hubcentric wheel adapters designed to adapt Ford/Volvo wheels with a 5/108 bolt pattern and 63.3mm center bore. Sold as a pair, these adapters allow fitment of wheels with a different bolt pattern than your vehicle's hub, opening up a wide range of wheel options while maintaining the safety and performance H&R is known for.
Unlike generic spacers, H&R TRAK+ Wheel Adapters are fully hubcentric, meaning they center precisely on the vehicle hub just like a factory wheel — eliminating vibration and ensuring proper load distribution. The wheel-side of the adapter features the target bolt pattern, enabling non-standard wheel fitment with confidence.
Key Features:
- Hubcentric design — centers on the vehicle hub for vibration-free fitment
- Adapts Ford/Volvo 5/108 bolt pattern wheels with 63.3mm center bore
- Sold as a pair (two adapters included)
- Available in thicknesses ranging from 20mm to 25mm
- Manufactured from a proprietary aluminum/magnesium alloy — up to 70% lighter than comparable steel
- Hard anodized finish for long-lasting durability and corrosion resistance
- Maximizes vehicle track width for improved lateral stability and handling
- Suitable for winter use with snow tires and wheels
Wheel Bolt Ordering Guidelines:
If your application requires new or longer wheel bolts, use the following specifications to ensure correct fitment and safety:
- New bolts must be longer than the originals by the width of the adapter used
- The bolt head type must match the original: Taper 60° (end digit 01), Round head M12/d24mm or M14/d28mm (end digit 02), Round head M12/d26mm OE VAG wheels (end digit 03), or Flat head Porsche OE M14×1.5 (end digit 06)
Minimum Wheel Bolt Engagement (Safety Guidelines):
- M12×1.25 — 8.0 turns (~10mm load-bearing shaft length)
- M12×1.50 — 6.5 turns (~10mm load-bearing shaft length)
- M12×1.75 — 6.5 turns (~12mm load-bearing shaft length)
- M14×1.25 — 9.0 turns (~12mm load-bearing shaft length)
- M14×1.50 — 7.5 turns (~12mm load-bearing shaft length)
- 1/2" UNF — 8.0 turns (~11mm load-bearing shaft length)
After installation, always rotate the wheel by hand to verify clearance inside the hub and confirm the wheel spins freely. Ensure wheel bolts do not contact ABS sensors or any brake system components. Note that maximum tolerance on some vehicles (such as the Mercedes rear axle) may be as little as 2mm.