The H&R TRAK+ DRM Series Wheel Spacers (Part #64215110) are premium hubcentric wheel spacers engineered to widen your vehicle's track width, improving both stance and handling dynamics. Sold as a pair, these DRM Series spacers bolt directly to the hub using your existing wheel studs and included special nuts, while the wheel is then bolted to the new DRM wheel studs — no separate bolt purchase required.
H&R TRAK+ Wheel Spacers push the wheel outward from the hub, filling the wheel well for a clean, flush fitment reminiscent of European performance vehicles. The result is a wider track width that lowers the vehicle's roll center and increases lateral stability for improved cornering and handling confidence.
DRM Series Overview:
The DRM Series provides 40–90mm of track widening. Spacers bolt to the hub using existing wheel studs with special nuts (included), and the wheel is then bolted to the new DRM wheel studs integrated into the spacer.
Key Features:
- Hubcentric design — seats precisely on the vehicle hub for vibration-free fitment
- 40–90mm track widening range in the DRM Series
- Sold as a pair — includes two spacers
- Mounts using existing wheel studs with included special nuts; wheel attaches to integrated DRM wheel studs
- Made from a proprietary aluminum/magnesium alloy — up to 70% lighter than comparable steel spacers
- Hard anodized finish for long-lasting corrosion resistance and durability
- Maximizes track width for improved lateral stability and lowered roll center
- Suitable for use with winter tire and wheel packages
Wheel Bolt Safety Guidelines (for DR/DRS Series reference):
If your application requires longer wheel bolts, replacement bolts must exceed original bolt length by the spacer thickness. Bolt head style must match the original (taper 60°, round head, or flat head). Minimum thread engagement requirements:
- M12 × 1.25 — minimum 8.0 turns (~10mm load-bearing shaft length)
- M12 × 1.50 — minimum 6.5 turns (~10mm load-bearing shaft length)
- M12 × 1.75 — minimum 6.5 turns (~12mm load-bearing shaft length)
- M14 × 1.25 — minimum 9.0 turns (~12mm load-bearing shaft length)
- M14 × 1.50 — minimum 7.5 turns (~12mm load-bearing shaft length)
- 1/2" UNF — minimum 8.0 turns (~11mm load-bearing shaft length)
After installation, rotate the wheel by hand to confirm clearance on the inside of the hub. Ensure wheel bolts do not contact any brake system components, including ABS sensors. Note: maximum tolerance on some vehicles (e.g., rear axle on Mercedes-Benz) may be as little as 2mm.