The H&R TRAK+ DRM Series Wheel Spacers (Part #56215110) are premium hubcentric wheel spacers sold as a pair, engineered to maximize your vehicle's track width for improved handling, enhanced stability, and aggressive fitment. The DRM Series mounts directly to the hub using your existing wheel studs and specially included nuts, with the wheel then bolting to the new DRM wheel studs — no separate bolt purchase required.
TRAK+ DRM Series — How It Works:
DRM Series spacers (40–90mm track widening range) bolt to the hub using the existing wheel studs with special nuts included. The wheel is then bolted to the new DRM wheel studs. This design provides a secure, hubcentric fitment that seats perfectly against the vehicle hub just as the OEM wheel would.
Key Features:
- Hubcentric design — ensures perfect centering on the vehicle hub for vibration-free performance
- Maximizes track width — improves cornering stability, lowers roll center, and increases lateral stability
- Proprietary aluminum/magnesium alloy construction — up to 70% lighter than a comparable steel spacer
- Hard anodized finish — provides a tough, corrosion-resistant surface for long-lasting durability
- DRM mounting system — uses existing wheel studs with included special nuts; new DRM wheel studs accept the wheel
- Sold as a pair — includes two spacers
- Excellent for winter use — compatible with snow tire and wheel setups
H&R TRAK+ Series Overview:
- DR Series (10–40mm) — fits between wheel and hub; requires separately purchased longer wheel bolts
- DRS Series (10–40mm) — fits between wheel and hub; includes replacement longer wheel studs
- DRA Series (40–60mm) — bolts to hub with included special wheel bolts; provides new threaded holes
- DRM Series (40–90mm) — bolts to hub via existing studs and included special nuts; wheel bolts to new DRM studs
Wheel Bolt Safety Guidelines (if applicable):
When sourcing replacement wheel bolts for other TRAK+ series, new bolts must be longer than originals by the width of the spacer. The bolt head must match the existing bolt type:
- Taper 60° — End digit 01
- Round head M12/d24mm or M14/d28mm — End digit 02
- Round head M12/d26mm (e.g., OE VAG wheels) — End digit 03
- Flat head for Porsche OE wheels M14×1.5 — End digit 06
Minimum thread engagement requirements: M12×1.25 = 8.0 turns (~10mm); M12×1.50 = 6.5 turns (~10mm); M12×1.75 = 6.5 turns (~12mm); M14×1.25 = 9.0 turns (~12mm); M14×1.50 = 7.5 turns (~12mm); 1/2" UNF = 8.0 turns (~11mm). Always verify that wheel bolts do not contact brake components (ABS sensors, etc.) and that the wheel rotates freely by hand after installation.