The H&R TRAK+ DRA Series Wheel Spacers (Part #5014580) are a premium hubcentric spacer solution engineered to maximize your vehicle's track width for improved handling, increased lateral stability, and a more aggressive stance. Sold as a pair, these spacers move your wheels outward from the hub, filling wheel wells for a purposeful, European-tuned look without sacrificing safety or performance.
DRA Series Design
The DRA Series is engineered for 40–60mm of track widening. Unlike DR or DRS spacers, DRA spacers bolt directly to the hub using special included wheel bolts and feature new threaded holes on the wheel-facing side — no separate bolt purchase required for most applications. This bolt-on design provides a secure, reliable fit with a clean installation.
Key Features:
- Hubcentric fitment — centers precisely on the vehicle hub for vibration-free performance
- 40–60mm track widening — optimizes stance, lowers roll center, and improves lateral stability
- Proprietary aluminum/magnesium alloy construction — up to 70% lighter than a comparable steel spacer
- Hard anodized finish — provides a tough, corrosion-resistant surface for long-term durability
- Special wheel bolts included — everything needed for installation is in the box
- Sold as a pair — includes two spacers
- Suitable for use with winter wheel and snow tire setups
TRAK+ Series Overview
H&R offers the TRAK+ line in multiple configurations to suit a wide range of applications:
- DR Series (10–40mm) — fits between wheel and hub; requires separately ordered longer wheel bolts
- DRS Series (10–40mm) — fits between wheel and hub; includes longer replacement wheel studs
- DRA Series (40–60mm) — bolts to hub with included special wheel bolts; features new threaded holes for the wheel
- DRM Series (40–90mm) — bolts to hub using existing wheel studs and included special nuts; wheel attaches to new DRM wheel studs
Wheel Bolt Selection Guidelines
When ordering additional or replacement wheel bolts for any TRAK+ spacer, follow these guidelines to ensure correct fitment and safety:
- New bolts must be longer than originals by at least the width of the spacer used
- The bolt head style must match your existing bolts exactly:
- Taper 60° — end digit 01
- Round head for M12/d24mm or M14/d28mm — end digit 02
- Round head for M12/d26mm (e.g., OE VAG wheels) — end digit 03
- Flat head for Porsche OE M14×1.5 wheels — end digit 06
Minimum Thread Engagement Requirements:
- M12×1.25 — 8.0 turns (~10mm load-bearing shaft length)
- M12×1.50 — 6.5 turns (~10mm load-bearing shaft length)
- M12×1.75 — 6.5 turns (~12mm load-bearing shaft length)
- M14×1.25 — 9.0 turns (~12mm load-bearing shaft length)
- M14×1.50 — 7.5 turns (~12mm load-bearing shaft length)
- 1/2" UNF — 8.0 turns (~11mm load-bearing shaft length)
After installation, turn the wheel by hand to verify full clearance from brake components, ABS sensors, and all interior hub surfaces. Note that maximum tolerance on some vehicles (such as the Mercedes rear axle) may be as little as 2mm.