The H&R TRAK+ DRA Series Wheel Spacers (Part #40145801) are a premium hubcentric wheel spacer solution engineered to widen your vehicle's track width between 40mm and 60mm. Sold as a pair, these spacers move your wheels outward from the hub, filling wheel wells more precisely and improving both stance and handling dynamics. Crafted from a proprietary aluminum/magnesium alloy, they weigh up to 70% less than comparable steel spacers without sacrificing strength or durability.
DRA Series Design:
The DRA Series spacers bolt directly to the hub using special included wheel bolts and feature new threaded holes on the wheel-facing side. This self-contained design means no separate bolt purchase is required — everything needed for installation is included in the box.
Key Features:
- Hubcentric design — fits flush to the vehicle hub for precise, vibration-free fitment
- 40mm–60mm track widening — optimized for aggressive fitment and improved stance
- Special wheel bolts included — no need to source additional hardware separately
- Proprietary aluminum/magnesium alloy construction — up to 70% lighter than steel equivalents
- Hard anodized finish — corrosion-resistant and durable for long-term use, including winter driving with snow tires
- Improves lateral stability — maximizes track width for a lower roll center and enhanced cornering performance
- Sold as a pair — includes two spacers
H&R TRAK+ Series Overview:
- DR Series (10–40mm) — fits between wheel and hub; requires separately purchased longer wheel bolts
- DRS Series (10–40mm) — fits between wheel and hub; requires longer wheel studs (included)
- DRA Series (40–60mm) — bolts to hub with included special wheel bolts; features new threaded wheel-side holes
- DRM Series (40–90mm) — uses existing wheel studs with included special nuts; wheel bolts to new DRM studs
Wheel Bolt Safety Guidelines (for reference):
When pairing spacers with wheel bolts, the replacement bolts must be longer than the originals by the spacer thickness used. Match the bolt head type to your existing hardware:
- Taper 60° — End digit 01
- Round head M12/d24mm or M14/d28mm — End digit 02
- Round head M12/d26mm (e.g., OE VAG wheels) — End digit 03
- Flat head for Porsche OE wheels M14×1.5 — End digit 06
Minimum engagement turns by thread pitch:
- M12×1.25 — 8.0 turns (~10mm load-bearing shaft length)
- M12×1.50 — 6.5 turns (~10mm load-bearing shaft length)
- M12×1.75 — 6.5 turns (~12mm load-bearing shaft length)
- M14×1.25 — 9.0 turns (~12mm load-bearing shaft length)
- M14×1.50 — 7.5 turns (~12mm load-bearing shaft length)
- 1/2" UNF — 8.0 turns (~11mm load-bearing shaft length)
After installation, rotate the wheel by hand to confirm clearance on the inside of the hub. Ensure wheel bolts do not contact ABS sensors or any brake system components. Note that maximum tolerance on some vehicles can be as little as 2mm (e.g., Mercedes rear axle).