The H&R TRAK+ DR Series Wheel Spacers (Part #4014580) are precision-engineered, hubcentric spacers that increase your vehicle's track width for improved handling, enhanced stability, and a more aggressive stance. Sold as a pair, these spacers fit between the wheel and hub to push the wheel outward, filling the wheel well for a cleaner, more purposeful look.
Series Overview
H&R TRAK+ spacers are available in several configurations to suit different applications:
- DR Series (10–40 mm track widening) — Fits between the wheel and hub. Requires longer wheel bolts, ordered separately. Verify bolt type before ordering (taper or round head, correct shaft length).
- DRS Series (10–40 mm track widening) — Fits between the wheel and hub. Requires exchanging existing wheel studs for longer ones (included).
- DRA Series (40–60 mm track widening) — Bolts directly to the hub using special wheel bolts (included) and provides new threaded holes for the wheel bolts.
- DRM Series (40–90 mm track widening) — Bolts to the hub using existing wheel studs and special nuts (included); wheel is then bolted to new DRM wheel studs.
Key Features:
- Hubcentric design for precise fitment and elimination of vibration
- Maximizes vehicle track width for improved lateral stability and reduced body roll
- Constructed from a proprietary aluminum/magnesium alloy — up to 70% lighter than comparable steel spacers
- Hard anodized finish for long-lasting corrosion resistance and durability
- Ideal for seasonal use with dedicated winter tire and wheel setups
- Sold as a pair
Wheel Bolt Selection Guidelines (DR Series)
When ordering replacement wheel bolts for use with DR Series spacers, follow these guidelines:
- New bolts must be longer than the originals by the width of the spacer used
- The bolt head style must match the original: Taper 60° (end digit 01), Round head M12/d24mm or M14/d28mm (end digit 02), Round head M12/d26mm — e.g., OE VAG wheels (end digit 03), Flat head for Porsche OE M14×1.5 wheels (end digit 06)
Minimum Wheel Bolt Engagement (Safety Guidelines):
- M12×1.25 — 8.0 turns (~10 mm load-bearing shaft length)
- M12×1.50 — 6.5 turns (~10 mm load-bearing shaft length)
- M12×1.75 — 6.5 turns (~12 mm load-bearing shaft length)
- M14×1.25 — 9.0 turns (~12 mm load-bearing shaft length)
- M14×1.50 — 7.5 turns (~12 mm load-bearing shaft length)
- 1/2" UNF — 8.0 turns (~11 mm load-bearing shaft length)
After installation, rotate the wheel by hand to confirm clearance on the inside of the hub. Ensure wheel bolts do not contact ABS sensors or any brake system components. Note that maximum tolerance on some vehicles may be as little as 2 mm (e.g., rear axle on certain Mercedes models).