The H&R 3355571L TRAK+ DR Series Wheel Spacers are sold as a pair and engineered to push your wheels outward from the hub, widening your vehicle's track for improved stance, handling, and lateral stability. Hubcentric by design, these spacers seat precisely against the vehicle hub for a safe, rattle-free fit. Made from a proprietary aluminum/magnesium alloy, they are up to 70% lighter than comparable steel spacers and feature a hard-anodized finish for long-lasting durability.
DR Series Overview:
DR Series spacers fit between the wheel and hub and provide 10–40 mm of track widening. Note: DR Series spacers require longer wheel bolts, which must be ordered separately. Before ordering bolts, verify your existing bolt head style (taper or round) and the required shaft length.
Key Features:
- Hubcentric design — seats directly on the vehicle hub for a precision, vibration-free fit
- 10–40 mm track widening — improves stance and fills wheel wells for a purposeful, aggressive look
- Proprietary aluminum/magnesium alloy — up to 70% lighter than comparable steel spacers
- Hard-anodized finish — resists corrosion for a tough, durable surface
- Sold as a pair — two spacers included per set
- Compatible with winter use — great for fitment with snow tires and dedicated winter wheels
TRAK+ Series Variations:
- DR Series (10–40 mm) — fits between wheel and hub; requires longer wheel bolts (ordered separately)
- DRS Series (10–40 mm) — fits between wheel and hub; requires longer wheel studs (included)
- DRA Series (40–60 mm) — bolts to hub with special wheel bolts (included); features new threaded holes for wheel bolts
- DRM Series (40–90 mm) — bolts to hub using existing wheel studs and special nuts (included); wheel bolts to new DRM wheel studs
Wheel Bolt Ordering Guidelines (DR Series):
- New bolts must be longer than original bolts by the thickness of the spacer used
- Bolt head must match the existing bolt style exactly:
- Taper 60° — End digit 01
- Round head M12/d24 mm or M14/d28 mm — End digit 02
- Round head M12/d26 mm (e.g., OE VAG wheels) — End digit 03
- Flat head for Porsche OE wheels M14×1.5 — End digit 06
Minimum Thread Engagement Safety Guidelines:
- M12×1.25 — 8.0 turns (~10 mm load-bearing shaft length)
- M12×1.50 — 6.5 turns (~10 mm load-bearing shaft length)
- M12×1.75 — 6.5 turns (~12 mm load-bearing shaft length)
- M14×1.25 — 9.0 turns (~12 mm load-bearing shaft length)
- M14×1.50 — 7.5 turns (~12 mm load-bearing shaft length)
- 1/2" UNF — 8.0 turns (~11 mm load-bearing shaft length)
After installation, rotate the wheel by hand to confirm it spins freely and that bolts do not contact any brake components, ABS sensors, or other hardware. Note that clearance tolerances on some vehicles can be as tight as 2 mm (e.g., rear axle on certain Mercedes models).