The H&R TRAK+ DR Series Wheel Spacers are precision-engineered hubcentric spacers designed to widen your vehicle's track width for improved stance, handling, and lateral stability. Sold as a pair, these spacers fit between the wheel and hub, pushing the wheel outward to fill the wheel well and deliver that coveted flush, European-tuned look.
How TRAK+ Spacers Work
H&R TRAK+ Wheel Spacers relocate the wheel outward from the hub, effectively widening the vehicle's track. This reduces body roll, lowers the roll center, and increases lateral stability — all while giving your vehicle a more aggressive, planted appearance. The DR Series provides 10–40mm of track widening and requires longer wheel bolts, which must be ordered separately.
Key Features:
- Hubcentric design — fits precisely to the vehicle hub, eliminating vibration and ensuring proper wheel centering
- Proprietary aluminum/magnesium alloy construction — up to 70% lighter than a comparable steel spacer
- Hard anodized finish — provides a tough, corrosion-resistant surface for long-term durability
- 10–40mm track widening range (DR Series)
- Sold as a pair
- Ideal for winter use with dedicated snow tire and wheel setups
DR Series Installation Notes
DR Series spacers mount between the wheel and the hub. Because they add thickness to the mounting surface, longer wheel bolts are required and must be ordered separately. Before ordering bolts, verify the following:
- New bolts must be longer than the originals by at least the thickness of the spacer used
- The bolt head style must match your existing bolts exactly:
- Taper 60° — End digit 01
- Round head M12/d24mm or M14/d28mm — End digit 02
- Round head M12/d26mm (e.g., OE VAG wheels) — End digit 03
- Flat head for Porsche OE wheels M14×1.5 — End digit 06
Wheel Bolt Safety Guidelines (minimum engagement turns):
- M12×1.25 — 8.0 turns (~10mm load-bearing shaft length)
- M12×1.50 — 6.5 turns (~10mm load-bearing shaft length)
- M12×1.75 — 6.5 turns (~12mm load-bearing shaft length)
- M14×1.25 — 9.0 turns (~12mm load-bearing shaft length)
- M14×1.50 — 7.5 turns (~12mm load-bearing shaft length)
- 1/2" UNF — 8.0 turns (~11mm load-bearing shaft length)
After installation, turn the wheel by hand and verify clearance on the inside of the hub. Ensure wheel bolts do not contact any brake system components, ABS sensors, or other hardware. Note that maximum tolerance on some vehicles (such as the Mercedes rear axle) may be as little as 2mm.
TRAK+ Series Overview
- DR Series (10–40mm) — Spacer fits between wheel and hub; longer wheel bolts required (sold separately)
- DRS Series (10–40mm) — Spacer fits between wheel and hub; longer wheel studs included
- DRA Series (40–60mm) — Bolts to hub with included special wheel bolts; provides new threaded holes for wheel bolts
- DRM Series (40–90mm) — Bolts to hub using existing studs with special nuts (included); wheel bolts to new DRM wheel studs