The H&R TRAK+ DR Series Wheel Spacers (Part #10234571SW) are precision-engineered hubcentric spacers designed to push your wheels outward from the hub, widening your vehicle's track for improved stance, handling, and lateral stability. Sold as a pair, these spacers are a popular choice among European car enthusiasts looking to achieve a flush, aggressive fitment without compromising safety or performance.
What Are TRAK+ Wheel Spacers?
H&R TRAK+ Wheel Spacers move your existing wheels outward from the hub, filling the wheel well for a cleaner look while simultaneously lowering the roll center and increasing lateral stability. The result is a more planted, responsive driving feel along with a distinctly purposeful appearance.
DR Series — How It Works
The DR Series spacers fit between the wheel and the hub and are designed for track widening in the 10–40mm range. Because the spacer adds thickness between the hub and wheel, longer wheel bolts are required and must be ordered separately. Before ordering bolts, verify the correct bolt head style (taper or round) and the required shaft length.
Key Features:
- Hubcentric design — centers precisely on the vehicle hub for a vibration-free fit
- Proprietary aluminum/magnesium alloy construction — up to 70% lighter than comparable steel spacers
- Hard anodized finish — provides a tough, corrosion-resistant surface for long-term durability
- Maximizes track width — improves handling, lowers roll center, and increases lateral stability
- Sold as a pair — two spacers included per set
- Winter-ready — compatible for use with snow tires and winter wheel setups
Wheel Bolt Guidelines (DR Series)
DR Series spacers require longer wheel bolts (not included). When selecting replacement bolts, keep the following in mind:
- New bolts must be longer than the originals by the thickness of the spacer used
- The bolt head style must match your existing bolts exactly (taper or round)
- Common bolt head types by end digit: Taper 60° — digit 01; Round M12/d24mm or M14/d28mm — digit 02; Round M12/d26mm (OE VAG wheels) — digit 03; Flat head Porsche OE M14×1.5 — digit 06
Minimum Thread Engagement Safety Reference:
- M12×1.25 — 8.0 turns (~10mm load-bearing shaft)
- M12×1.50 — 6.5 turns (~10mm load-bearing shaft)
- M12×1.75 — 6.5 turns (~12mm load-bearing shaft)
- M14×1.25 — 9.0 turns (~12mm load-bearing shaft)
- M14×1.50 — 7.5 turns (~12mm load-bearing shaft)
- 1/2" UNF — 8.0 turns (~11mm load-bearing shaft)
After installation, turn the wheel by hand to confirm free rotation and verify clearance on the inside of the hub, particularly around ABS sensors and brake components. Note that maximum tolerance on some vehicles may be as little as 2mm (e.g., rear axle on Mercedes models).