BD Diesel 1064262BM TorqueMaster 68RFE Transmission Converter Package 2007.5-2018 Dodge 2WD Billet Input

The BD Diesel TorqueMaster 68RFE Transmission and Converter Package is a complete, dyno-tested matched set engineered for ultimate performance and reliability in 2007.5-2018 Dodge 2WD applications. This comprehensive package combines a fully built transmission with a ProForce 3D triple-disc torque converter and features a billet input shaft to handle rapid throttle response and high horsepower demands.

Transmission Enhancements:

• Hard anodized valve body with new solenoid pack installed in every unit
• Custom bonded gasket valve body separator plate increases line pressure while stopping internal cross leaks
• Heavy duty cam and roller design Low-Reverse one-way clutch
• New 4C billet spring retainer for increased durability
• Steel girdle added to 2C piston allowing for more clutches and broader apply area
• BD durable QT100 pressure plates with increased clutch counts to reduce deflection and distortion
• Overdrive and 2C clutches increased by 33 percent for improved holding capacity
• Custom Big Stack Overdrive shaft
• BD reinforced accumulator plate
• TCC limit valve machined and sleeved to address high wear areas within pump
• BD deep sump oil pan adds extra fluid and cooling capacity while reducing case flex
• BD ProTech68 pressure control module ramps up line pressure to 250 PSI using MAP sensor to adjust pressure based on load
• Performance billet input shaft handles snap from rapid throttle and high horsepower applications

ProForce 3D Torque Converter Features:

• Triple-disc design with enhanced stall for street and towing applications
• Heavy-duty springs absorb shock of engagement
• Stamp forged one-piece cover eliminates warpage from clutch heat
• Taller cover design can be rebuilt more often for extended service life
• Trapezoid teeth design with engineered tighter tolerances
• Self-centering trapezoid teeth increase contact area, decrease wear and chatter
• Thrust bearings instead of plastic thrust washers for improved durability
• Riveted piston ensures alignment and eliminates vibration
• Cast stator design maximizes torque multiplication
• New sprag components ensure long-term durability
• Furnace brazed turbine fins for improved fluid coupling efficiency
• Reduced overall weight by 12 lbs compared to competitor designs

Warranty Coverage:

• Parts: 36 months or 150,000 miles
• Labor: 12 months or 24,000 miles
• Note: Race abuse not covered

Installation: Approximately 9 hours estimated install time. Professional installation recommended.

Ideal for towing, street performance, or track applications where dependable power transfer and durability are essential. This package is designed to stand up to the extreme power and torque demands of modified diesel engines.